iPSG

iPSG Support Article

Subject: USB External Hard Drive Enclosure - IDE Drive Installation Instructions

To replace the IDE hard drive in the enclosure-

1. Remove 2 screws from back and slide the sides off (towards rear), then split enclosure in half.

2. Connect the IDE cable, and power connector.

3. Place the drive on the bottom of the enclosure and screw into place using 4 screws.

4. Put enclosure back together and slide the sides on. Replace the 2 screws that hold them in place.

Disclaimer: This information is being provided to you as a service from the Technical Support Department of IPSG (The International Products Sourcing Group). It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should contact IPSG through our web site. IPSG will not be held responsible for any loss of information, data or programming as a result of the use of this article.

COMPUTERS
- PowerSpec
- WinBook

BUILD YOUR OWN PC
- Motherboards and Bundles

COMPONENT UPGRADES
- CD-R/DVD-R Drives
- External Storage
- Hard Drives
- Video Cards

PERIPHERALS
- Mice/Keyboards
- Notebook Adapters
- Surge Protection/UPS
- USB Hubs
- USB Card Readers/Media
- USB Storage

ELECTRONICS
- Cameras/Photo Frames
- Gadgets
- MP3 Players
- Portable DVD/Video Players

SUPPLIES
- Blank Media
- Notebook Batteries
- Printer Cartridges
- Sleeves and Cases

TV/MONITORS
- LCDTV/Monitors
- Wall Mounts/Stands